Industrial type DKC-1A stepper motor controller pulse generator servo potentiometer speed

Industrial type DKC-1A stepper motor controller pulse generator servo potentiometer speed Wide voltage input,5-32DC; With a power anti-reverse protection , overvoltage protection, overcurrent protection, complete protection of the safety controller Signal input point for bottom -level input; OptimizedSType acceleration curve Maximum output frequency can be achieved20K All opto-isolated inputs and outputs Board planted potentiometer speed , external potentiometer speed automatic switching A variety of functions , set up a simple , functional and practical , volume 5 * 8.2CM Function modes are:

1: Automatic shuttle mode

2 : Single Entry Mode

3 : Single-Shot mode

4 : Jog mode

:( Automatic control applications a round-trip mode )

1EquipmentAPointBRunning back and forth between points.

After the device is powered , external trigger startOperation, equipment operation toAPoint Forward LimitAfter running the automatic reversalBPointAfter reversing limit ,Forward run again toAPoint , so run back and forth . Until the trigger to stop the motor stops running.

Parameter settings:

1Set upSW1=OFF,SW2=OFF( Automatic shuttle mode )

2. Onboard governorOr external potentiometer,Adjust the appropriate speed.

:( Control application two single -shot mode )

1Equipment fromAPoint toBAfter stopping point . Again to stop the boot device from B to A points.

After the device is powered , external trigger startRuns from the device toAPointDeparture , when the device is running toBPoint Forward LimitAfter the device stops running , if you start again from point B to reach the trigger deviceAPoint , the device stops. Start upA-\\u003e B stop, start, B-\\u003e A stop motion process . If the trigger to stop the motor running in the device to stop running immediately .

Parameter settings:

1Set upSW1=OFF,SW2=ON( Single Shot mode )

2. Onboard governorOr external potentiometer,Adjust the appropriate speed.

:( Control applications three single round trip mode )

1Equipment fromAPoint toBA point after point to return to the stop .

After the device is powered , external trigger startRuns from the device toAPointDeparture , when the device is running toBPoint Forward LimitAfter the device is running a reverse rotation when it arrivesAPoint , the motor stops. Complete a

A-\\u003e B-\\u003e A motion process . If the trigger to stop the motor running in the device to stop running immediately .

Parameter settings:

1Set upSW1=ON,SW2=OFF( Single round-trip mode )

2. Onboard governorOr external potentiometer,Adjust the appropriate speed.

Control applications four :( jog mode )

1External switch controller starts again completely stopped, reversing.

After power on the device to start the input of the bottom level of the motor forward run ,

Bottom level undo , the motor stops .

To stop the input of the bottom level of the motor reverse run ,

Bottom level undo , the motor stops .

Parameter settings:

1Set upSW1=ON, SW2 = ON( Jog mode )

2. Board governorOr external potentiometer,Adjust the appropriate speed.

Tags: pulse generator, speed control potentiometer, speed controller, Cheap pulse generator, High Quality speed control potentiometer, China speed controller Suppliers.